Jaquet D12P - Differential Hall Effect Speed Sensor - Square Wave Signal Output from Push-Pull Stage w/M12x1 1.0" Thread

The Jaquet D12P series Differential Hall-Effect Speed sensors are suitable, in conjunction with a ferrous pole wheel, for generating square wave signals proportional to rotary speeds. They exhibit a dynamic function, whereby pulse generation down to 5 Hz is guaranteed. The sensor must be oriented with respect to the pole wheel as shown in the dimensional drawing (see spec sheet below).

Features:

• Signal Output: Square Wave signal from push-pull output stage, DC-coupled to the supply, 30 mA max. load current
• Thread Length: 1.9" M12x1 thread
• 8-32 DCV Supply Voltage
• 15 mA (without load) maximum current consumption
• 5-20 kHz Frequency Range
• Housing: M12x1, tightening torque: max 12 Nm
• Connection: Cable with Connector:
• Cable: 3-wire, 3 X 0.21 mm2 (AWG24), 350 mm (13.75") length, stranded wires, PTFE isolation, green casing
• Connector: AMP 282105-1, 3 pins
• Operating Temperature: -104-257°F (-40-125°C)
• Protection: IP68 (Sensor) / IP67 (Cable)
• Insulation: housing and electronics galvanically isolated (Test: 500V, 50 Hz for 1 minute)

Additional Info

• Digital Magnetic & Hall Effect Sensors
• Connector